We have configured below mentioned topics in Zepto POC cluster.
Network Interface - LAN & WAN
SD-WAN Rule
SD-WAN Network
WLAN
1. Network Interface - LAN & WAN
First we have configured WAN port on Port1 which is DHCP and Port4 as Secondary DHCP wan, and LAN has been configured on port2 and 3 configuration as below.
you can check interface configuration from Profile > Network Interface
1.1 WAN-Airtel (WAN) - DHCP metric value of 1 and Port1
1.2. ACT-IIL (Secondary WAN) -Static metric Value of 40 and Port4
1.3. lanconfig (LAN) - 192.168.15.1/24 on port 2 and 3
2. SD-WAN Rule for Active-Active Traffic: SD-WAN rule define redundancy of WAN up link where we assign both WAN links and provide priority.
you can check SD-WAN Rule configuration by following below steps.
here we have configured both links as Active-Active Load-balancing.
Your Cluster > SD-WAN > SD-WAN Rule
As below we have gave name to profile as Active-Active and Check interval value as 2 sec every 2 sec system will check both links failure.
On first interface we have selected WAN-BB interface and applied default SLA.
set Weight as 1 and Priority as High.
Weight define packet distribution and Priority define Link Priority it self , Because we have gave same weight and same priority it will work as Active-Active and Load-Balancing.
Packet will go one by one from both links as well as both link will be available for fail-over.
3. SD-WAN Network : SD-Wan will provide connectivity between multiple branches.
follow below steps to check and update config for SD-wan. because SD-WAN created at parent level got to parent cluster.
Parent Cluster > SD-WAN > Networks
here you can see SD-WAN overview like Network port, Tunnel IP, Topology, Tunnel Type and Public IP
You can check SD-WAN members from below steps
Here you can see 2 members where is HUB and Spoke is located, These members are RAY Gateway device only which are added in child clusters.
from here you can add new device to SD-WAN add remote device for SSL VPN. and device details like name, appliance, SD-WAN Ip, and Type
One device has been added as HUB and other device as Spoke. from action button you can configure and modify and restart SD-WAN members.
In below snap you can see device Role as HUB and Routed subnet which are clusters Local subnet which we have routed to outside HUB reachable from Spoke devices.
4. Wireless LAN : In which we have define which SSID should be visible with authentication method
Go to Cluster > Profile > Wlan
Here we have mentioned SSID name As "Zepto_MH4_AP" and authentication we have used WPA2 and lan we have selected which we have created in network interface section.
