Steps 1: Go to the SD-WAN Interface section, select SD-WAN Rules, and click Force Re-Publish. Wait for 20–30 minutes. 

If the issue persists, proceed to Step 2. 

 

 



Steps 2: Go to the Profile Interface section, select Appliance Settings, and click Force Re-Publish. Wait for 20–30 minutes. 

If the issue persists, proceed to Step 3. 


 


 

Steps 3: Go to the Appliance section, open Dashboard Settings, check the appropriate box, and click Apply OTA. Then wait for 20–30 minutes for the changes to take effect.


 


Note: SD-WAN data will only be displayed if there is a valid license subscription that start with Protect subscription.